Owner’s Manual 2009

34 35
3. Compress the spring and replace the recoil buffer assembly.
4. Replace the set screw, making sure the hole in the action spring guide
is aligned with the set screw hole and the set screw through the hole
in the action spring guide.
5. With a small punch, gently tap in the pin located to the rear of the
action spring guide set screw.
IMPORTANT: The pin must be tapped in from the right to the left side.
6. Install the magazine block by
inserting it into the receiver and
aligning the hole in the receiver
with the holes in the magazine
block and pushing the pin
through the receiver. Use a
2.5mm Allen wrench to install
the two screws on either side of
the magazine block.
7. Replace the right action bar by
placing the bolt in the forward
position. Place the projecting
section of the action bar
carefully in its corresponding slot in the bolt before the action bar is fit
onto the inertia block (Figure 25). The action bars are interchangeable.
8. Replace the bolt lock. Align the hole in the bolt lock with the hole in
the receiver and insert the bolt lock pin.
9. Secure the bolt lock spring onto the bolt lock using a standard
screwdriver or needle nose pliers.
10. Replace the left action bar by placing the projecting section of the
action bar carefully in its corresponding slot in the bolt before the
action bar is fit onto the inertia block. It may be necessary to pull the
inertia block slightly rearward to engage the action bars.
very lightly oiled cloth after cleaning. The gas cylinder interior and the
gas piston should not be oiled beyond this.
WEAR EYE PROTECTION WHEN DISASSEMBLING AND
CLEANING YOUR RIFLE TO PREVENT SPRINGS, SPRING-
LOADED PARTS, SOLVENTS OR OTHER AGENTS FROM
CONTACTING YOUR EYES, RESULTING IN INJURY.
Notice! DO NOT USE TOO MUCH LUBRICANT. EXCESSIVE
LUBRICATION COULD INTERFERE WITH THE FUNCTION OF
YOUR RIFLE.
19.2. REASSEMBLY
1. Replace the gas piston in the
gas cylinder.
2. Slide the action spring down the
action spring guide and insert
the action spring/action spring
guide assembly through the
inertia block and into the piston.
IMPORTANT: At the rear of the
action spring guide there is a hole that the set screw must pass
through. When sliding the action spring guide into the piston make
sure to align the hole on the action spring guide with the set screw
hole on the receiver (Figure 24). It may be helpful to access the action
spring guide through the magazine well to help align the hole in the
action spring guide with the set screw hole.
FAILURE TO TIGHTEN THE SET SCREW AGAINST THE INDEX
MARK IN THE ACTION SPRING GUIDE COULD CAUSE THE
FIREARM TO MALFUNCTION OR CAUSE SERIOUS INJURY TO
YOU AND OTHERS.
FIGURE 24
Align the action spring guide hole with the set
screw hole.
FIGURE 25
Insert the action bars into the slots on the
bottom of the bolt.