Owner’s Manual 2011

32 33
19. MOUNTING ACCESSORIES
BEFORE MOUNTING ACCESSORIES ON YOUR SHOTGUN,
PLACE THE “SAFETY” IN THE ON SAFE POSITION. UNLOAD
THE MAGAZINE, OPEN THE ACTION AND MAKE CERTAIN
YOUR SHOTGUN IS COMPLETELY UNLOADED. KEEP THE
MUZZLE POINTED IN A SAFE DIRECTION. FAILURE TO
FOLLOW THESE WARNINGS COULD RESULT IN SERIOUS
INJURY OR DEATH.
SLP Tactical models are fitted with three MIL-STD 1913-pattern
mounting rails on the magazine sleeve to attach various accessories
to the shotgun. When installing accessories, follow the manufacturers
mounting instructions.
20. STOCK ADJUSTMENT (TACTICAL MODELS)
BEFORE PERFORMING STOCK ADJUSTMENT PROCEDURES,
PLACE THE “SAFETY” IN THE ON SAFE POSITION. OPEN
THE ACTION, UNLOAD THE MAGAZINE AND MAKE CERTAIN
YOUR SHOTGUN IS COMPLETELY UNLOADED. KEEP THE
MUZZLE POINTED IN A SAFE DIRECTION. FAILURE TO
FOLLOW THESE WARNINGS COULD RESULT IN SERIOUS
INJURY OR DEATH.
SLP Tactical models include three recoil pads of different lengths and three
combs of different height. These accessories allow the stock to be adjusted
to fit the size of the operator.
20.1. ADJUSTING LENGTH OF PULL
Three recoil pads have been included with your shotgun to allow precise
length of pull adjustments. The short recoil pad is
1
⁄2" thick, the medium
recoil pad is
3
⁄4" thick and the long recoil pad is 1" thick. The medium recoil
SLP shotguns are designed to accept a scope or other optical sight.
Standard SLP models have a drilled and tapped receiver with a MIL-STD
1913 base. Mark I models include a barrel-mounted, weaver-type cantilever
rail. Always follow the mounting instructions supplied with your scope rings
and/or scope or optical sight.
18. EXTRA BARRELS
BEFORE INSTALLING ACCESSORY BARRELS ON YOUR
SHOTGUN, READ THE FOLLOWING GUIDELINES TO ENSURE
THE BARREL/SHOTGUN COMBINATION IS SAFE. PLACE THE
“SAFETY” IN THE ON SAFE POSITION. OPEN THE ACTION
AND MAKE CERTAIN YOUR SHOTGUN IS COMPLETELY
UNLOADED. KEEP THE MUZZLE POINTED IN A SAFE
DIRECTION. FAILURE TO FOLLOW THESE WARNINGS COULD
RESULT IN SERIOUS INJURY OR DEATH.
The versatility of your new shotgun can be extended with an extra barrel.
Most shotgun barrels are interchangeable within a given model, gauge and
chamber length. No special fitting is required. However, some important
restrictions must be observed:
• Never use a barrel with a 3½" chamber on a shotgun designed for
barrels with a 3" chamber.
• Never use a barrel with a 3" chamber on a shotgun designed for
barrels with a 3½" chamber.
• Never use any other barrel from any other manufacturer on your
shotgun. Some other brands may seem similar, but the barrels are
not interchangeable.
• Never use a barrel from Winchester
®
shotguns, including those for the
Super X
®
1, Super X
®
2 or Super X
®
3.