Owner’s Manual 2011

30 31
Each click generated during this
operation will change the vertical
position of the point of impact by
5mm (0.20") at 25 meters (30 yards).
SLP STANDARD FRONT SIGHT
ELEVATION ADJUSTMENT
The point of impact can be moved up
by moving the front sight down,
turning its socket screw just in front
of the sight blade in the clockwise
direction by using the 1.5mm hex
wrench provided (Figure 13, page 30).
Each click generated during this operation will change the vertical point
of impact by 10mm (0.40") at 25 meters (30 yards).
Reverse these directions to move the sight and point of impact in the
opposite direction.
16.2. SLP MARK I SIGHTS
The SLP Mark I incorporates a low-profile, blade-type rear rifle sight. The
rear sight is adjustable for both windage and elevation. The front sight is
fiber-optic design that is designed for fast target engagement.
SLP MARK I REAR SIGHT
The SLP Mark I incorporates a fold-
down rear sight located on the front
of the sight rail. With the rear sight in
the up position the sight aligns
with the fixed front sight. When
folded down, the lengthwise groove in
the cantilever can be used as a
sighting plane, aligning with the
front fiber-optic sight for extremely
fast sighting situations.
SLP MARK I REAR SIGHT WINDAGE ADJUSTMENT
Windage adjustment is accomplished by drifting the rear sight in the
dovetail. Carefully tap the sight with a hammer using a non-marring drift
punch against the sight base (Figure 14, page 31). Drift the sight to the left
to move the point of impact to the left. Drift the sight to the right to move the
point of impact to the right.
SLP MARK I REAR SIGHT ELEVATION ADJUSTMENT
The rear sight is adjusted for elevation using the two small screws on the
rear of the sight (Figure 15, page 31). Loosen them slightly and move the
sight blade up or down to adjust the point of impact. Move the blade up to
move point of impact up. Move the blade down to lower point of impact. Snug
the screws after making adjustments.
17. SCOPE OR OPTICS MOUNTING
BEFORE MOUNTING A SCOPE, SIGHT OR OTHER
ACCESSORIES TO YOUR SHOTGUN, PLACE THE “SAFETY” IN
THE ON SAFE POSITION. UNLOAD THE MAGAZINE, OPEN THE
ACTION AND MAKE CERTAIN YOUR SHOTGUN IS COMPLETELY
UNLOADED. KEEP THE MUZZLE POINTED IN A SAFE
DIRECTION. FAILURE TO FOLLOW THESE WARNINGS COULD
RESULT IN SERIOUS INJURY OR DEATH.
FIGURE 12
Turn the screw on the top of the sight to
adjust elevation.
FIGURE 13
Turn the screw in front of the sight to
adjust elevation.
FIGURE 15
Loosen the screws and slide the sight blade up
or down to adjust for elevation.
FIGURE 14
Carefully tap the sight in the dovetail to adjust
for windage.