Owner’s Manual 2011

28 29
15.2. CHOKE TUBE REMOVAL
1. Place the “safety” in the on safe
position. Always make sure the
shotgun is completely unloaded.
Always keep the muzzle pointed
in a safe direction.
2. Use the choke tube wrench to
loosen the tube, turning it
counterclockwise. Finger-twist the
tube the rest of the way out of the
barrel (Figure 10, page 28).
15.3. CHOKE TUBE INSTALLATION
1. Place the “safety” in the on safe position. Always make sure the
shotgun is completely unloaded. Always keep the muzzle pointed in
a safe direction.
2. Before installing a tube, check the internal choke tube threads in the
muzzle, as well as the threads on the choke tube to be sure they are
clean. Lightly oil the threads with a high-quality, lightweight gun oil.
3. Using your fingers, screw the appropriate tube into the muzzle of the
barrel, threaded end first, notched end outward. When it becomes
finger-tight, use the choke tube wrench to firmly seat the tube.
Notice! THE CHOKE TUBE SHOULD BE PERIODICALLY
CHECKED TO ASSURE THAT IT IS TIGHT AND FIRMLY
SEATED. BEFORE CHECKING, FOLLOW ALL CHOKE TUBE
REMOVAL AND INSTALLATION “SAFETY” GUIDELINES
PREVIOUSLY OUTLINED.
16. SIGHT ADJUSTMENT
BEFORE PREFORMING ANY SIGHT ADJUSTMENT
PROCEDURES TO YOUR SHOTGUN, PLACE THE “SAFETY” IN
THE ON SAFE POSITION. UNLOAD THE MAGAZINE, OPEN
THE ACTION AND MAKE CERTAIN YOUR SHOTGUN IS
COMPLETELY UNLOADED. KEEP THE MUZZLE POINTED IN A
SAFE DIRECTION. FAILURE TO FOLLOW THESE WARNINGS
COULD RESULT IN SERIOUS INJURY OR DEATH.
16.1. SLP STANDARD SIGHTS
The SLP Standard incorporates a high-profile, ghost ring rear rifle sight
mounted on a MIL-STD 1913 rail on top of the receiver. The rear sight is
adjustable for both windage and elevation. The front sight is a high-profile,
wing-protected post design adjustable for elevation.
SLP STANDARD REAR SIGHT WINDAGE ADJUSTMENT
The point of impact can be moved toward the right by moving the rear sight
towards the right, turning the screw on the right side of the sight in the
clockwise direction using a flat-blade screwdriver (Figure 11, page 29).
Each click generated during this operation will change the lateral position
of the point of impact by 1.5mm (0.06") at 25 meters (30 yards).
SLP STANDARD REAR SIGHT
ELEVATION ADJUSTMENT
The point of impact can be moved up
by moving the rear sight up, turning
the screw on the top of the sight in
the counterclockwise direction using
a flat-blade screwdriver (Figure 12,
page 30).
FIGURE 10
Remove the choke tube.
FIGURE 11
Turn the screw on the side of the sight to
adjust windage.