Addendum 2015

Figure 1

1. Contents of the Storage Case

 SLP Competition Shotgun

 Safety lock and two keys

 A single gold-rimmed piston, installed

 Extended Invector Plus™ Improved Cylinder Choke, installed

 Invector Plus™ choke wrench

 Sling Swivel Set

 Extra receiver plug screws (4)

 Owner’s Manual

2. Gas Piston

The SLP Competition ships with a single gas piston. FNH USA has recently

updated the piston springs in the SLP shotguns. The result is a single piston

that services all loads, 2 ¾” and 3”, 1 1/8

ounce to 1 5/8

ounce with a 24”

barrel. This new universal piston is already installed in your SLP

Competition Shotgun. It is identified with a gold rim on its base and is

marked, “FN SLP 1 1/2oz and heavier.” Your FNH SLP Competition will

function best with target loads intended for sporting and competition use

such as 1 1/8

and 1 ¼ ounce loads.

Note that in Section 10, page 18 of your SLP Owner’s Manual, it references two pistons, one red for light loads

and one black for heavy loads. These have been replaced by the single, universal Gold Rimmed piston. In

Section 2, page 3, it also references two pistons. Two pistons are no longer needed and therefore not included.

3. Sight Adjustments

The SLP Competition is equipped with a low-profile, blade-type fold down rear sight that is adjustable for

elevation and a fiber optic front sight that is adjustable for windage. If you find it necessary to adjust the point of

impact, please follow the below instructions instead of those in the SLP Autoloading Shotgun Owner’s Manual as

those instructions refer to the SLP standard and Mk I sights:

WARNING

Before performing any sight adjustment procedures to your shotgun, place the “safety” in the on safe

position. Unload the magazine, open the action and make certain your shotgun is completely unloaded.

Keep the muzzle pointed in a safe direction. Failure to follow these warnings could result in serious injury

or death.