Owner’s Manual 2016

6.2. Cleaning and lubrication after firing

❖

Carry out the field stripping procedure (refer to § 5.1).

Barrel support and upper rail group

• Using a cleaning brush or a spray, apply solvent inside

the bore of the barrel and let the product work a few

minutes.

• Using a cleaning rag holder and clean rags (pieces of

flannel), remove the functional lubricant, the solvent and

the residues from the bore of the barrel until the last rag

is clean.

• When the barrel is clean, again use a piece of flannel,

this time moistened with maintenance lubricant, to

protect the bore of the barrel until the next use.

Please note that the bore of the barrel should be wiped dry

before shooting (also refer to § 6.1).

• Clean the barrel

support and upper

rail group with a soft

cloth.

Frame and trigger group

• Clean with a soft, dry cloth. If necessary, use water or a

soft solvent.

Moving parts group

• Using a cleaning brush and solvent, remove any carbon

and other deposits.

• If necessary, rinse in a soft solvent and then dry by using

a soft cloth.

• Move the breech block rearward along its guide rods

and then clean the guide rods.

Barrel

Cocking

handle