Owner’s Manual 2016

27
To reassemble the magazine, follow the above steps in
reverse order, taking into account the following points :
Î
Ensure that all components of the magazine are perfectly
clean.
Î
Ensure that the 2 rollers are inserted one behind the other into
the magazine body.
Î
Ensure that the magazine follower assembly is oriented
correctly.
Also refer to the pictogram which can be found on the side of the
magazine body.
Î
The magazine bottom plate can only be slid back into position
when the magazine bottom lock is pushed and held flush with
the edge of the magazine body.
Î
Ensure that the magazine bottom plate correctly locks into
position.
❖
Carefully release the pressure on the magazine follower
assembly.
❖
Take the magazine follower assembly out of the magazine
body.
❖
Hold the magazine body slightly inclined in order to remove
the 2 rollers.
&
&
Magazine bottom plate
Magazine body
Magazine
bottom lock
Magazine follower assembly
Rollers
&
This level of disassembly is sufficient to perform thorough
cleaning : further disassembly should only be carried out
by a FN Recommended Service Center / your
departmental armorer.