Owner’s Manual 2016

23
❖
Ensure that the magazine is empty.
If the magazine is not empty, unload it by pushing the cartridges, one
by one, forward with the thumb.
❖
Pull the cocking handle completely rearward and then release
it in order to extract and eject the remaining cartridge from
the chamber.
Repeat this operation at least 3 times in order to ensure that the
chamber is empty.
Please note that, after this operation, the hammer is cocked.
❖
Pull the cocking handle completely rearward and hold it in
that position.
❖
Through the magazine opening, look into the chamber of the
carbine in order to ensure that there is no cartridge in the
chamber.
If there is a cartridge in the chamber, try to extract and eject it by
releasing the cocking handle and then pulling it again completely
rearward.
❖
If the chamber is empty, release the cocking handle.
❖
Set the fire selector at the position ‘1’ (single-shot).
❖
Pointing the carbine in a safe direction, pull the trigger to
decock the hammer.
❖
Set the fire selector at the position ‘S’ (safe).
❖
Fit the empty magazine back into position.
When the magazine is on the carbine, the last 2 cartridges and the
cartridge in the chamber are not visible.
The magazine must therefore always be removed and the chamber
cleared in order to ensure that the carbine is empty !
Chamber
Cocking handle
&