Owner’s Manual 2013

42 43
22.4. REINSTALLATION OF THE TRIGGER GROUP
1. The bolt assembly, slide arms and forearm should be attached to the
receiver before installing the trigger group.
2. Ensure the hammer is in the cocked position by pushing it straight
back until it locks into place and the “safety” is in the on safe position.
3. Turn the shotgun over with the open bottom of the receiver facing
upward. Hold the trigger group at an angle to the receiver (about 45
degrees) and then engage the front tabs on the trigger group with the
corresponding slots in the magazine throat at the forward end of
receiver opening as shown in Figure 13 on page 40.
4. Carefully insert the front of the trigger group into the receiver opening,
then lower the rear into the receiver opening until it is parallel with the
receiver. It may be necessary to slide the forearm into different
positions until the trigger group fits flush into the receiver. When
properly installed it will fit easily and the trigger group pin hole will
be in alignment.
NOTICE! Be careful when reinstalling the trigger
group. never force parts into position. Do not attempt
to install the Bolt assemBly after the trigger group
is installeD. failure to follow these instructions may
Damage your firearm.
5. Align the trigger group with the hole in the receiver and push the
trigger group pin through the receiver until it is flush with both sides
of the receiver. The pin should pass through easily with little force. If
significant resistance is felt, remove the trigger group and repeat
step 1.
Your firearm is now fully assembled. Immediately confirm that the “safety”
is in the on safe position. Take time to wipe down and clean all external
surfaces as explained under “Cleaning and Maintenance Suggestions”
on page 35.
22.3. ASSEMBLY OF THE FIRING PIN, BOLT AND SLIDE
1. Reinstall the firing pin spring over the firing pin. Either end of the
spring can go on first.
2. Insert the firing pin/spring assembly into the rear opening of the bolt
slide, pin end first.
3. To reinstall the bolt assembly on the slide arm, push or compress the
knob end of the firing pin sufficiently into the hole in the bolt slide so
that the large space between the grooved knob and the flange on the
firing pin is centered in the round hole in the bolt slide.
4. Place the curved tongue, located on the slide arm, into the space
between the knob and flange and slowly release pressure on the end of
the firing pin. Let the flange on the firing pin pull the tongue toward
the rear of the bolt assembly.
5. Remove the magazine cap.
6. Hold the slide arms and bolt/slide arm assemblies together (Figure 14).
Start the forearm assembly onto the magazine tube.
7. Carefully guide the slide arms and bolt/slide arm assemblies into the
front of the receiver. As the assemblies enter the receiver, slide them
fully rearward (Figure 15).
FIGURE 14
Position the bolt assembly on the slide arms.
FIGURE 15
Carefully guide the bolt assembly, on the slide
arms, onto the receiver.