Owner’s Manual 2013
30 31
15.1. P-12 REAR SIGHT
The P-12 incorporates a fold-down rear sight. With the rear sight blade in
the up position the sight notch aligns with the fixed front sight. When the
rear sight is folded down, the lengthwise groove in the cantilever rail can
be used as a sighting plane, aligning with the front fiber-optic sight for
extremely fast sighting situations.
15.2. P-12 REAR SIGHT WINDAGE ADJUSTMENT
Windage adjustment is accomplished by drifting the rear sight in the
dovetail. Carefully tap the sight with a hammer using a non-marring drift
punch against the sight base (Figure 10). Drift the sight to the left to move
the point of impact to the left. Drift the sight to the right to move the point
of impact to the right.
15.3. P-12 REAR SIGHT ELEVATION ADJUSTMENT
The rear sight is adjusted for elevation using the two small screws on the
rear of the sight (Figure 11). Loosen them slightly and move the sight blade
up or down to adjust the point of impact. Move the blade up to move point
of impact up. Move the blade down to lower point of impact. Snug the
screws after making adjustments. DO NOT OVERTIGHTEN SCREWS.
16. ELECTRONIC DOT SIGHT, SCOPE OR OPTICS MOUNTING
BEFORE MOUNTING A SCOPE, SIGHT OR OTHER
ACCESSORIES TO YOUR SHOTGUN, PLACE THE “SAFETY” IN
THE ON SAFE POSITION. UNLOAD THE MAGAZINE, OPEN THE
ACTION AND MAKE CERTAIN YOUR SHOTGUN IS COMPLETELY
UNLOADED. KEEP THE MUZZLE POINTED IN A SAFE
DIRECTION. FAILURE TO FOLLOW THESE WARNINGS COULD
RESULT IN SERIOUS INJURY OR DEATH.
P-12 shotguns are designed to accept an electronic dot sight, scope or
other optical sight on the barrel-mounted, Weaver-type cantilever rail.
Always follow the mounting instructions supplied with your scope rings
and/or scope or optical sight.
17. EXTRA BARRELS
BEFORE INSTALLING ACCESSORY BARRELS ON YOUR
SHOTGUN, READ THE FOLLOWING GUIDELINES TO ENSURE
THE BARREL/SHOTGUN COMBINATION IS SAFE. PLACE THE
“SAFETY” IN THE ON SAFE POSITION. OPEN THE ACTION
AND MAKE CERTAIN YOUR SHOTGUN IS COMPLETELY
UNLOADED. KEEP THE MUZZLE POINTED IN A SAFE
DIRECTION. FAILURE TO FOLLOW THESE WARNINGS
COULD RESULT IN SERIOUS INJURY OR DEATH.
The versatility of your new P-12 shotgun can be extended with an extra barrel.
Most shotgun barrels are interchangeable within a given model, gauge and
chamber length. No special fitting is required. However, some important
restrictions must be observed:
•Neveruseabarrelwitha3½"chamberonashotgundesignedfor
barrels with a 3" chamber.
FIGURE 10
Carefully tap the rear sight base in the
dovetail to adjust for windage.
FIGURE 11
Loosen the screws and slide the sight blade up
or down to adjust for elevation.