Owner’s Manual 2009

26
• Using a 3/32” drift punch and a small hammer, slightly move
the rear sight towards the right or left side in its housing in the
slide assembly.
At both sides of the slide, a hole has been provided in order to correctly
reach the dovetail of the rear sight with the drift punch.
Never try to move the rear sight by applying a force on its external
surfaces as this could cause damage to the slide or to the rear sight.
In order to move the point of impact towards the left side, slightly move
the rear sight towards the left side.
In order to move the point of impact towards the right side, slightly move
the rear sight towards the right side.
• Using the 0.05” allen key, tighten the small screw on top of the
rear sight.
• Reassemble the pistol as described in § 5.1.