Owner’s Manual 2020

42
11.3.1 BACKSTRAP INSTALLATION
1. Slide the backstrap up the dovetail onto the rear of the frame
(Figure 55).
2. Press the backstrap into position closing the gap between the top of
the backstrap and grip. Ensure the retaining pin hole in the backstrap
is aligned with the slot in the dovetail in the frame (Figure 56).
3. Using the back of a punch or a hard surface push the retaining pin
into the backstrap. Use the small roll pin punch to center the pin in
the backstrap (Figure 57).
FIGURE 56
Seated backstrap.
FIGURE 55
Backstrap installation.
FIGURE 57
Backstrap pin installation.