Owner’s Manual 2020

6. Place the disconnect lever over the boss on the left side of the chassis

above the trigger bar (Figure 54).

11.3.2 INSTALLING THE CHASSIS ASSEMBLY IN THE GRIP ASSEMBLY

1. While holding the trigger bar and associated parts in place, slide the

chassis assembly into the grip by inserting the trigger through the

trigger hole, slide the chassis down and back into the grip until the

chassis retaining pin holes in the grip and chassis are aligned (Figure

55).

2. Drive the chassis retaining pins through the grip and chassis from left

to right while supporting the right side of the gun on a rigid surface.

The pins should be at or below flush on both sides of the grip (Figure

56).

NOTE: The chassis retaining pins are not intended to be removed regularly.

After repeated disassembly and reassembly the chassis retaining pins may

FIGURE 55 FIGURE 56