Owner’s Manual 2020

chassis. The straight leg points

upward and the bent leg points to

the rear when installed

(Figure 50).

3. Install the trigger bar onto the

chassis by placing the hole in the

trigger bar over the upper boss of

the trigger lever and the leg of the

trigger bar through the window on

the right side of the chassis (Figure

51).

4. While holding the trigger bar in

place, place the short leg of the

trigger bar spring against the shelf

below the trigger bar and the loop

of the spring over the lower lug of

the trigger lever (Figure 52).

5. Press the upper leg (longer leg) of

the trigger bar spring down while

retaining the trigger bar and

bottom leg of the trigger bar spring

until the upper leg can slide under the trigger bar and into the groove

cut into the bottom of the trigger bar (Figure 53).

FIGURE 51

FIGURE 53

FIGURE 52

FIGURE 54