Owner’s Manual 2020

spring will no longer be positively retained. Disassemble the pistol in an

area where you will be able to find any dropped parts.

4. Remove the trigger bar spring, trigger bar, disconnect lever and slide

stop spring and set them aside (Figure 49).

NOTE: This level of disassembly is all that is required to interchange grip

assemblies.

11.3.1 INSTALLING THE SLIDE STOP SPRING, TRIGGER BAR, TRIGGER BAR

SPRING AND DISCONNECT LEVER

1. Insure the sear and striker block lever move freely, the sear has spring

tension to return it to the up position and the sear and ejector pins are

fully pressed into place.

NOTE: The sear and ejector pins

should not be removed. If the ejector

pin is not staked in place, the pistol

should be returned to have the pin

replaced and staked in place.

2. Install the slide stop spring in

its recess in the left side of the

FIGURE 49

FIGURE 50