Owner’s Manual 2020

38
and is ready to be loaded and fired.
11.3 GRIP REMOVAL
The frame assembly does not need to be disassembled for normal
maintenance but disassembly will be necessary to reconfigure the pistol
with different grips or to clean the pistol if exposed to a corrosive
environment such as salt water.
CAUTION: It is recommended that the sear pin and ejector pin not be
removed from the pistol. If it becomes necessary to remove the sear pin or
ejector pin, we recommend returning
the pistol to an FN authorized service
center. The ejector pin must be
replaced if removed.
1. Field strip the pistol as
described in section 11.1.
2. Drive the roll pins out from left
to right using a hammer and roll
pin punch (Figure 47).
CAUTION: Support the right side of
the grip when driving out the roll pins
to avoid damage to the grip.
3. Lift up on the front of the
chassis and pull it out of the
grip (Figure 48).
CAUTION: When the chassis is
removed from the grip, the disconnect
lever, trigger bar, and trigger bar
FIGURE 47
FIGURE 48