Addendum – 2015

WARNING
Before removing, moving or reattaching the rear sight, place the “safety” in the on safe position, remove the
magazine, open the action and ensure the chamber is empty as explained in Section 15.1 of your Owner’s
Manual. Always keep the muzzle pointed in a safe direction. Failure to follow these warnings may result in
serious injury or death.
2.3 Rear Sight Removal; Removal or moving of the rear sight is easily
accomplished with a 5/32
nd
inch hex wrench (not included). First, place the
“safety” in the on safe position and completely clear the carbine as explained in
Section 15.1 in your Owner’s Manual. The rear sight is meant to be mounted in
the rear-most position on the receiver top rail.
2.3.1 Sight Removal; Insert a 5/32
nd
inch hex wrench in the locking screw located on the left side of the sight
assembly. Turn the screw counterclockwise to loosen. It is not necessary to completely remove the screw in order
to remove the sight.
2.3.2 Sight Installation; To install the rear sight, ensure the locking screw is loose
and the locking lug on the right side is extended. Rotate the sight onto the rail
from the left side, ensuring the locking screw aligns with one of the T-slots on the
receiver. Record which rail T-slot for future reference. Rotate the sight onto the
rail until it sits level on the rail. Tighten the locking screw on the left side using a
5/32
nd
inch hex wrench ensuring the locking lug on the right side grabs the rail and
secures the sight to the rail. Do not over tighten the locking screw.
WARNING
Before installing any sights, lasers or other devices on the carbine, place the “safety” in the on safe position,
remove the magazine, open the action and ensure the chamber is empty as explained in Section 15.1 of your
Owner’s Manual. Always keep the muzzle pointed in a safe direction. Failure to follow these warnings may
result in serious injury or death.