Instructions for use

❏

5. You have now completed the assembly of the high

wing conﬁ guration of the Mini Switch!

CHANGING TO THE LOW WING

CONFIGURATION

Once you are accustomed to ﬂ ying the high wing conﬁ guration,

it’s time to move the wings and give the low wing conﬁ guration

a try. You will ﬁ nd that the lower wing position changes the

aerobatic characteristics of the plane. In general, the low

wing will perform most aerial maneuvers better than the high

wing. You may ﬁ nd the control response a little slower, but

also smoother, than the high wing.

❏

1. Remove the wing panels from the high wing

conﬁ guration canopy hatch by disconnecting the aileron

Y-harness, loosening the wing joiner screw and sliding the

panels off of the joiner tube.

❏

2. Remove the battery hatch by sliding the lever forward

and lifting the hatch away. Push the wing pocket plugs out

and set them aside for later use.

❏

3. Loosen the outer wing screws three complete turns.

❏

4. Insert the wing joiner tube through the joiner tube

holes in the fuselage.

❏

5. Slide the wing panels onto the wing joiner. The

aileron servo leads should ﬁ t through the slots in the

fuselage sides. Be sure the panels are fully seated against

the fuselage inside the wing pockets. Tighten the inner

wing screws against the wing joiner tube. Pull on the wing

panels to conﬁ rm they won’t separate in ﬂ ight.