Instructions for use

10
● NEVER discharge below 2.75V per cell.
● NEVER place on combustible materials or leave
unattended during charge or discharge.
● ALWAYS KEEP OUT OF REACH OF CHILDREN.
Check the Control Directions
❏
1. With the battery fully charged, turn on your
transmitter and move the throttle stick (left stick) down
to the idle position. Then, plug the motor battery into the
ESC. If the ESC makes an erratic pattern of beeps after the
initial startup beeps and a few seconds of silence, then it
has entered programming mode and the throttle channel
needs to be reversed on the transmitter, following Step 2.
If not, skip Step 2. Take care around the propeller! The
propeller will rotate when the throttle is advanced.
(Complete ESC programming instructions are included on
page 15 of this manual)
❏
2. Disconnect the battery from the ESC. Then, move the
throttle reversing switch on the transmitter. Confi rm that the
throttle stick is still in the idle position and reconnect the
battery to the ESC.
FULL
THROTTLE
RUDDER
MOVES
RIGHT
ELEVATOR
MOVES DOWN
RIGHT AILERON
MOVES UP
LEFT AILERON
MOVES DOWN
4-CHANNEL RADIO SETUP (STANDARD MODE 2)
❏
3. View the model from behind and move the rudder
control (left stick) on the transmitter to the left. The rudder
should move to the left. If not, move the rudder reversing
switch on the transmitter and then test the operation of the
rudder again.
❏
4. Moving the elevator control down (right stick) should
cause the elevator to move up. Flip the elevator reversing
switch on the transmitter if necessary.
❏
5. Moving the aileron control to the right (right stick)
should cause the left aileron to move down and the right
aileron to move up. Flip the aileron reversing switch on the
transmitter if necessary.