User Manual

5
ATTENTION: There is a clear band securing the throttle
and elevator pushrods in place on the fuselage. DO NOT
remove this band. The band keeps the pushrods from flexing
during flight.
Wing Assembly
1. Insert the wing tab into the fuselage.
2. Lower the back of the wing down onto the fuse until the
magnets lock it in place.
ATTENTION: Make sure the wing is properly seated before
each flight.
Charging the Battery (RTF)
WARNING:
● Read the LiPo battery warnings on page 2 carefully
and charge the battery accordingly.
● Use only the battery charger specified.
● Do not attempt to charge a damaged or swollen
battery. This may cause fire or serious damage.
● Do not attempt to charge a fully charged battery.
Run down the battery completely before attempting
to charge the battery.
● Do not leave the charger unattended while charging.
1. Remove the charger door from
the transmitter.
2. Connect the 3.7V 200 mAh LiPo
battery to the charge socket (A)
so the Up label is visible.
3. The charge lamp (B) lights up
and charging starts. A fully
discharged battery takes about
40 minutes to charge.
4. After the charge lamp goes off,
charging is complete.
NOTE: When the transmitter
batteries are dead, the battery
cannot be charged. The battery
can be charged whether the
transmitter power is switched
ON or OFF. If you have an
additional Micro Calypso battery,
you can charge while flying.
USB Charger Instructions
(Tx-R Version Only)
Approximate charge time is 1 hour.
1. Plug the Micro Calypso USB charger into a USB charge
port on your computer or USB adapter (like the one used
for cell phones).
2. Plug the Micro Calypso battery into the charger. The red
LED on the charger should illuminate.
3. Once the battery is charged the red LED will shut off.
4. Once the red LED shuts off remove the battery and charger
from the USB port.
5. Do not leave the charger unattended while charging.
3.7 V
200 mAh
LiPo
Battery
Charge
Lamp