User Manual

3
AVAILABLE PARTS
FLZA6460 Wing
FLZA6461 Tail Surface Set
FLZA6462 Landing Gear Set
FLZA6463 Propeller (2 pcs.)
FLZA6468 Battery LiPo 1S 3.7V 150 mAh
PARTS GUIDE
V-Stabilizer
Rudder
H-Stabilizer
Elevator
Elevator Push Rod
Rudder
Push Rod
Main
Wing
Horn
Horn
Propeller
TRANSMITTER
1 Mode Change Switch
2 Power Switch
3 Elevator Trim (Up/Down)
Adjust up/down so plane flies horizontal.
4 Elevator Stick (Up/Down)
Controls planes upwards/downwards movement.
Rudder Stick (Left/Right)
Controls plane’s left/right movement.
5 Rudder Trim (Left/Right)
Adjust left/right so plane flies straight.
6 Throttle Trim (Up/Down)
Adjusts throttle so motor will not move at the down
position.
7 Throttle Stick (Up/Down)
Controls propeller speed.
8 Function Selector
123456
CH1 CH2 CH4
REVERSER
CH1 CH2 CH3
D/R-Dual Rate
ON
9 Battery Level Indicator
10 Charge Lamp
11 Battery Cover
12 Charger Terminal Cover
BEFORE OPERATING
Batteries for Transmitter
Remove
Battery
Cover
Confirm
Polarity
Markings
Re-Install
Battery
Cover
AA Alkaline
Batteries x 4
ASSEMBLING THE AIRPLANE
1. Install the landing gear into
the landing gear mount from
the front as shown. Make sure
to fully push the landing gear
in place to prevent it from
coming off during use.
2. Install the main wing onto the fuselage by clipping the plastic
mounts on the wing into the holders on the fuselage. Note the
direction in the drawing. Make sure to fully push the mounts
into the clips to prevent the wing from coming off during use.
Make sure to re-check the fit of the mounts on the clips if you
crash your plane.