User Manual

Center the Control Surfaces

Down

Centered

❑

1. Turn on the transmitter, lower the throttle stick all the

way to 0%, and center the trims.

❑

2. Connect the battery to the ESC. The motor will emit a

series of tones indicating the cell count of the battery and

a rising series of tones indicating the ESC is now armed.

WARNING: Make sure this propeller is not installed

for this next step.

A magnetic screwdriver, or a small magnet stuck to a

screw driver to make it magnetic, will be helpful for the

next couple of steps.

❑

3. Remove the screw from the connector on the elevator

servo arm.

❑

4. Lightly wet the threads of the screw with threadlocker.

❑

5. Reinstall the screw, but do not tighten yet. With the

transmitter and receiver on, center the elevator and tighten

the screw to lock the pushrod down.