User's Manual
FS-HW-G4P&HW-709
Digital Proportional Radio Control System
10
Beginner mode is designed for people new to the hobby.
In this mode the throttle will be limited to 50 percent, The channel range defaults to
1250~1500~1750us.
Setup:
To switch between beginner and normal modes press and hold the channel 4 button as the
transmitter is turned on.
Note: By default, the system is set to normal mode. The GLED will flash slowly for 3 seconds
during power on if the system is set to beginner mode.
5.7 Beginner Mode
5.8 ESC Parameter Setting
Dial Switch sign
The Dial Switch on the transmitter is used to set ESC parameters, that is, the Dial Switch is
located at different positions and the corresponding parameter values are different.
Setting Method:
There are three parameters can be set for the ESC, which are "Running mode", "Battery type",
"Drag brake", There are slide switches numbered 1 2 3 4 on the radio panel . The above
parameters can be set by dialing left and right. The specific operation is as follows:
When No. 1 slide switch is on the left, it indicates that the operation mode is set to FWD / REV /
BRK.
When No. 1 slide switch is on the right, it indicates that the operation mode is set to FWD/REV.
When No. 2 slide switch is on the left, it indicates that the battery type is set to Lipo.
When No. 2 slide switch is on the right, it indicates that the battery type is set to NiMH.
When No. 3 and No.4 slide switch are on the left, it indicates that the drag brake force is set to 0%.
When No. 3 slide switch is on the left and No.4 slide switch is on the right, it indicates that the
drag brake force is set to 50%.
When No. 3 slide switch is on the right and No.4 slide switch is on the left, it indicates that the
drag brake force is set to 75%.
When No. 3 and No.4 slide switch are on the right, it indicates that the drag brake force is set to
100%.