User's Manual
FS-G4P
Digital Proportional Radio Control System
6
4.Instructions
After setting up, follow the instructions below to operate the system.
Follow the steps below to turn on the transmitter:
1. Check to make sure that that battery is fully charged and installed correctly.
2. Toggle the switch to the [ON] position. When active the R.LED will be lit.
3. Connect the receiver to power.
• For safety always power on the transmitter before the receiver.
4.2 Binding
The transmitter and receiver have already been bound at the factory.
1. Turn on the transmitter while holding the bind button to enter bind mode. G.LED will start
flashing quickly.
• Once in bind mode release the bind button.
2. The receiver will enter bind mode atomically when powered on.
3. Once binding is successful the receiver’s LED will flash slowly and the transmitter’s LED
will remain solid after being rebooted.
Note: When binding, put the transmitter into bind mode first, then the receiver.
4.1 Power On
However if the receiver needs to be replaced or additional receivers bound follow these steps:
Note
• Operate with caution in order to avoid damage or injury.
Note
• Makesurethatthethrottleisatitslowestpositionandtheswitchesaresettotheirup
position.
• applicable to the FS-G4P transmitter and the FR-R4P receiver. Different receivers have
different bind procedures. For more information visit the FLYSKY website for manuals and
other related information.
• Product information is updated regularly, please visit our website for more information.