User's Manual

5
3.
GettingStarted
Before operation, install the battery and connect the system as instructed below.
3.1
TransmitterBatteryInstallation
Danger
• Only use speci󽗉ed battery (X4 AA batteries).
Danger
• Do not open, disassemble, or attempt to repair the battery.
Danger
• Donotcrush/puncturethebattery,orshorttheexternalcontacts.
Danger
• Donotexposetoexcessiveheatorliquids.
Danger
• Donotdropthebatteryorexposetostrongshocksorvibrations.
Danger
• Alwaysstorethebatteryinacool,dryplace.
Danger
• Donotusethebatteryifdamaged.
Battery Type: AA
Battery Installation:
1. Open the battery compartment cover.
2. Insert 4 fully-charged AA batteries into the compartment. Make sure that the battery makes good contact with the
battery compartment's contacts.
3. Replace battery compartment cover.
Low battery alarm: When the battery is lower than 4.2v, the G.LED on the panel will flash slowly