User's Manual

10. 2.4GHz Operation notes
10.01. Matching(code)/Binding
2.4G操作注意事项
All receivers are already paired with their respective transmitter during production. If you wish to bind it with another
transmitter, please follow the instructions below.
Remark: FS - brand system are not compatible with other brands
Steps:
1. Ensure you are using AFHDS2A system
2. Correctly install the battery inside 2.4G transmitter w/o powering it on.
3. Insert the binding plug into the BIND channel slot on the receiver. (Figure.1).
4. Using a correct receiver battery pack, plug it in to VCC channel slot on the receiver. At this time, the LED on receiver should
flash, indicating receiver has entered bind status.
5. Press and hold the binding button on transmitter, and then switch on the transmitter.
6. Observe the LED light on the receiver. If LED stops flashing, and stays lit permanently, the binding procedure is completed.
(This process takes approximately 5S.)
7. Release hold the binding button on the transmitter, and unplug the bind cable.
8. Install the servos to test.
9. If the system does not work properly, repeat the procedure.
(The above binding instruction is only suitable for any FLYSKY 2.4G products)
我们的产品在出厂前已经过配对，您无需做配对动作便可使用。但如果您要将接收机跟另外的发射机进行配对使
用，或者您要更换新的接收机或者发射机，请您按如下的步骤进行：
注：我们的接收发射系统。不跟其它品牌兼容！
1.确保发射机为AFHDS2A系统
2.将2.4G发射机装好电池，并关闭发射机。
3.将配对线插入接收机的BIND通道接口（如图1)
4.将接收机电池插入接收机的VCC通道接品，此时可看到接收机的LED在闪烁，此表示接收机进入配对状态。
5.将发射机上的配对键（BIND)按住，然后打开发射机电源开关。（注：不要松开按键）。
6.观察接收机上的LED，如果发现LED不再闪烁表示配对成功。（注：此过程大约时间为5S左右）。
7.松开发射机上的配对按键，拔掉接收机上的配对线。
8.将柌服器装上并通电测试
9.如果测试NG，则重复以上动作
注：以上配对方法，仅适合于FLYSKY的2.4G产品。
LED
Figure1(图1）
Match line
对码线
Receiver
接收机
Battery
电池
对码按钮
Bind key
对码