User's Manual

18
FS-l6S
Digital proportional radio control system
Setup:
1. If the mix is not already disabled turn it off by touching the box labeled "on".
2. Select a master by touching the box to the right of the master channel and choose a channel from the
list.
3. Select a slave by touching the box to the right of the slave channel, then choose a channel from the
list.
4. If needed, set an offset on the slave channel. Select the box to the right of the offset function, select
the correct decimal and use the up and down arrow keys to change the value. Press the
or to
confirm or cancel changes.
5. Set the positive ratio using the box to the right of "pos", select the correct decimal and use the up
and down arrow keys to change the value. Press the
or to confirm or cancel changes.
6. Set the negitive ratio using the box to the rigt of "neg", select the correct decimal and use the up and
down arrow keys to change the value. Press the
or to confirm or cancel changes.
7. Once all changes have been made toggle the function to on by touching the box to the right of "Mix".
8. Select the
icon to save and return to the previous menu.
6.6 Failsafe Function
The failsafe function enables you to pre-set channel positions for the receiver in case of signal loss.
Setup:
1. To setup a failsafe position on a channel, select the channel
from the list, to select the channel touch the box to the right of the
channel name.
2. The box next to the channel name should display "On", to actavate
the failsafe touch the box. The box should now display "Off"
3. Move and hold the channel at the desired position, then while
keeping the channel at the desired value touch the setup box.
Set all:
It is possible to set all the channels at the same time, to do so first
turn all the channels on as stated above, hold all the channels in the
desired position and select "Set all" at the bottom of the list. The
system will prompt for a comfirmation, select "Y" for yes.
To Reset all channels, select the "Reset all" option.
Select the
icon to save and return to the previous menu.
6.7 Bri./Sound
This function controlls screen brightness and
volume for the system.
To make changes to brightness or volume touch
and drag the black box located within the relavent
slider. Then select the
icon to save and return
to the previous menu.