User's Manual

17
6.4 Aux. Channels
The auxiliary channels can be used to control additional part of a model such as landing gear or lights.
1. Select channels using the left or right arrow keys on the screen on either side of the channel name.
2. The left box below the channel name allows the user to pick the type of control for that channel, Nul,
VRx, Stx, KEY and SWx.
3. Select the icon to save and return to the previous menu.
Note:
• If the channel is in use for a fly mode, the system will inform the user and prevent any changes
to that channel.
6.5 Mix
The mix function creates a mix between 2 different channels. For example, it is possible to make a mix
between rudder and ailerons, so whenever the model rolls, the rudder will move automatically to perform
a turn.
Note: In order to make changes to the mix it must first be disabled.
• Master: This channel will control the slave.
• Slave: This channel is controlled by the master.
• offset: Offset works like trim or sub trim allowing for the centre position of the slave channel to be
changed.
• Pos: Changes how much the slave will move in relation to the master in a positive movement. At 50%
when the master moves to 100% of its positive motion, the slave will move to positive 50%.
• Neg: Changes how much the slave will move in relation to the master in a negative movement. At
50% when the master moves to 100% of its negative motion, the slave will move to negative 50%.