User's Manual

16
FS-l6S
Digital proportional radio control system
6. Function Settings
6.1 Reverse Function
The reverse function changes a channels direction of movement
in relation to its input. For example, if the blades are spinning in
the wrong direction, pushing the model into the ground instead
of taking off, this function can be used to correct this.
Setup:
To change between normal and reverse touch the box to the
right side of the desired channel.
Nor = Normal, Rev = Reverse.
Select the
icon to save and return to the previous menu.
6.2 Endpoints Function
The endpoint function changes the range of movement available to a channel. This can be used to limit
the tilt of the model, so that it is easier to control.
The left box is the low endpoint, the right box is the high endpoint, marked below as low being blue and
red being high.
To change an endpoint:
1. Touch the low or high endpoint box.
2. Touch the desired decimal to change then use the onscreen
up and down arrows to change the value.
3. Press the or to confirm or cancel changes.
4. Select the
icon to save and return to the previous
menu.
6.3 Subtrim Function
Subtrim changes the center point of the channel. For example, if a model is always drifting to one side,
the sub trim can be used to fix this.
To set the subtrim function:
To change the subtrim:
1. Touch the box to the right of the desired channel.
2. Select the correct decimal and use the up and down arrow keys.
3. Press the or to confirm or cancel changes.
4. Select the
icon to save and return to the previous menu.