User's Manual

参数说明：
CHANNEL：通道编号，通道ST到通道AUX。
ST. RBU通道右边微调, 调整量为00%--100%,工厂预设值为00%;
ST. LFU通道左边微调, 调整量为00%--100%,工厂预设值为00%;
TH. LFU通道前进微调, 调整量为00%--100%,工厂预设值为00%;
TH. RBU通道后退微调, 调整量为00%--100%,工厂预设值为00%;
AUX. RBU通道CH3向上微调, 调整量为00%--100%,工厂预设值为00%;
AUX. LFU通道CH3向下微调, 调整量为00%--100%,工厂预设值为00%;
操作方法：
在开机菜单下通过“确认”键进入菜单，通过“左右旋转”键进行TRIM菜单选择，再按确认键进入此菜单的操作（此时ST
字符会闪烁），然后通过“左右旋转”键进行通道ST到通道AUX的选择，选好要变更的通道后，按“END”键，此时两个字
符会闪烁，在此状态下通过按“左右旋转”键进行00%--100%设定调整，完成后按“END”键切换通道的设定，此时ST会
闪烁。以此类推，对三个通道进行设定。
编辑完成后，按“确认”键返回并进入菜单选择状态。
在任何状态下，按“返回”键，进入开机画面。
ST
16
TRIM
Function:
Use this function to adjust the neutral position of the steering, throttle and AUX channel.
Parameter:
CHANNEL: channel number, from ST to AUX
ST. RBU: steering or 3rd channel right side , adjustment range: 00%--100% ( initial value is 00% )
ST. LFU: steering or 3rd channel right side, adjustment range: 00%--100% ( initial value is 00% )
TH. LFU : throttle forward side, adjustment range: 00%--100% ( initial value is 00% )
TH.RBU: throttle backward side , adjustment range : 00%--100% ( initial value is 00% )
Operation:
Press the " ENTER" button and turn to the “TRIM” menu. Press the “ENTER” button to enter the
“TRIM” menu. The selected channel will be blinking. Select the channel by turning the "ENTER"
button, and then press the "END" button (now the percentage will be blinking). Turn the "ENTER"
button to adjust the rate. After this, press the "END" button to finish the setting. The rest can be done
in the same way. Press the "ENTER" button to save and return to menu screen. Press the "BACK"
button to return to the opening screen.
GT3X
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM