USM-GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM 用户手册 This product is suitable for 15 years old and above 本产品不适合15岁以下儿童使用
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM Special symbols GT3X 特殊标志 Please pay attention to the following symbols when they appear in the manual and read carefully. 当以下标志出现在说明书的时候请注意并且仔细阅读。 Not following these instructions may expose the user to serious injuries or death. 如果使用者不按照说明方法操作,有可能导致使用者严重受伤,甚至致命的危险。 Not following these instructions may expose the user to serious injuries.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X Do not operate outdoors on rainy days, run through puddles of water or use when visibility is limited. Should any type of moisture (water or snow) enter any component of the system, erratic operation and loss of control may occur.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM System Characteristic GT3X 系统特征 This radio system works in the frequency range of 2.405 to 2.475GHz. This band has been divided into 142 independent channels. Each radio system uses 16 different channels and 160 different types of hopping algorithm. By using various switch-on times, hopping scheme and channel frequencies, the system can guarantee a jamming free radio transmission. 此系统工作频率范围是2.405到2.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X TRANSMITTER 1 2 5 6 7 3 4 1 2 5 6 3 Ch3 TRIM CH3 4 7 A A 6 5
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X A E B D C F G H I A LCD B BACK F ST TRIM(RIGHT) 6 C D END E ENTER(DOWN/UP) G ST TRIM(LEFT) H TH TRIM(UP) I TH TRIM(DOWN)
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM Operation instruction GT3X 接收机操作说明 Receiver and servo connections 接收机与伺服器连接 ESC ON/OFF SWITCH 注意: 为保证良好的遥控距离,请将接收机天线与飞机机身垂直放置并远离金属物体。 Note: To ensure good remote control distance, please set the receiver’s antenna on the vehicle vertically and away from metal objects. Receiver 接收机 Connector instruction 接口说明 CH1-CH6: 表示接收机的相应通道; BAT: 表示用于对码和输入电源的通道; CH1-CH6: represents corresponding channels. BAT: represents the binding channel and power supply channel.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM 发射机参数 Transmitter specifications Transmitter specifications: Number of channels: 3 Channel resolution: 1024 steps Power supply: 6V (1.5 V AA x 4) Low voltage warning: <4.2. Red LED will flash 4.2-4.5V Red 4.6-5V Orange 5-6V Green <3.2 V Buzzer goes off to alarm 2.4 GHz type: AFHDS. USM-GT3X Antenna length: 26mm*2(dual antenna ) Color: Black Size: 174*89*190mm Weight: 335g Certification: CE、FCC 机种参数 1. 通道个数:3 2. 数据分辨率: 1024级 3. 输入电压: 6V (1.5 V AA x 4) 4.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM Binding GT3X 对码 The supplied transmitter and receiver are already bound at production time. If you are using another transmitter or receiver, you need to bind them before use : 1. Install batteries in the transmitter and turn it off. 2. Connect the binding jumper cable to the battery port on the receiver. 3. Connect the battery of the receiver to any channel on the receiver. The red LED on the receiver will blink, indicating it is in binding mode. 4.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X LCD FUNCTION EXPLANATION LCD DISPLAY BUTTON FUNCTION: Turn the “ENTER” button counterclockwise: decrease the rate Turn the “ENTER” button clockwise: increase the rate Press “ENTER” button: select the menu Press “BACK” button: return to the menu Press “END” button: end programming 按键定义: 左旋:逆时针旋转(做菜单选择及数据减); 右旋:顺时针旋转(做菜单选择及数据加); 确认:确认按键(做菜单选择确定); 返回:返回按键(菜单返回); END:(结束某一项功能编辑的操作键)。 OPENING SCREEN Show current model number and user name Turn the “ENTER” butto
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X MODEL Function : The radio system has the ability to store ten model memories (USM0-USM9), each model memory can be setup individually to match up with different models. Parameter: The initial model No. is Model “1". “”USM” is for the name of model. Operation: Press the “ENTER” button and turn to the “MODEL” menu. Press the “ENTER” button to enter the “MODEL” menu. There are a total of 10 model memories from 0-9.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X SUB-T Function: This function allows the user to sub trim the steering "ST", throttle "TH", or auxillary "AUX" channels.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X REV Function: This function reverses the operating direction of the channels: steering, throttle, and channel 3. Parameter: CHANNEL: channel number, ST, TH, AUX REV: reverse NOR: normal Operation: Press the "ENTER" button and turn to the “REV” menu. Press the “ENTER” button to enter the “REV”menu. The channel function will be blinking. Select the channel by turning the "ENTER" button. Then press the "END" button (now the "REV" or " NOR" will be blinking).
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X NAME Function: This function allows you to assign a user name (three characters) to each model memory. Parameter: MODEL NO: Model number. ”USM”: User name Operation: Press the “ENTER” button and turn to the “NAME” menu. Press the “ENTER” button to enter the “NAME” menu. The first letter will be blinking. Turn the “ENTER” button to select letter. Press the “END” button to move between the three letters.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X CRAW Function: This function allows the usage of 4 wheel steering for specifically for crawling or other vehicles that require mixing. Parameter: There are 4 different modes to control the composition of the direction. Model A: channel 1 control Model A direction. Model B: channel 1 control Model B direction, reversed control. Model C: channel 1 control Model A direction, channel 3 control model B direction, channel 3 replicates channel 1 data.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X TRIM ST Function: Use this function to adjust the neutral position of the steering, throttle and AUX channel. Parameter: CHANNEL: channel number, from ST to AUX ST. RBU: steering or 3rd channel right side , adjustment range: 00%--100% ( initial value is 00% ) ST. LFU: steering or 3rd channel right side, adjustment range: 00%--100% ( initial value is 00% ) TH. LFU : throttle forward side, adjustment range: 00%--100% ( initial value is 00% ) TH.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X ALB Function: while applying the brakes, locking them up can be easily done. which can cause your vehicle to spin out of control, this can be eliminated by pulsing the brakes, so that full control of your vehicle can be achieve at all times. The effect as like that of a A.B.S in a real passenger car. Parameter: CHANNEL: channel number, it’s only available in channel 2: OFF: A. B. S.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X EXP Function: This function is used to change the sensitivity of the 2 channels around the neutral position. In order to “soften” or make aggressive the response, according to user 's demand. Parameter: CHANNEL: channel number, from ST and TH; 100%: steering “EXP” rate, when you want aggressive steering operation, turn the button to increase the rate. When you want to make steering operation less aggressive, turn the button to decrease the rate.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X EPA Function: Use this function when performing left and right steering angle adjustments, throttle high side/brake side amount adjustment, and channel 3 servos up side/down side operation amount adjustment during linkage setup. Used to correct steering angle of adjusting left and right steering angles when there is a difference in the left and right turning radios. Parameter: CHANNEL: channel number, from St to AUX 100%:output value.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X D/R Function: By setting the dual rates function, you can limit the total travel of each individual Channel. Parameter: CHANNEL: channel number, channel ST 100%:Dual Rate, when you want to increase the servo travel, turn the button to increase the rate. when you want to decrease the servo travel, turn the button to decrease the rate.0% is no signal output ,100% is maximum signal output.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X FAIL SAFE FUNCTION E Function: Failsafe aims to prevent control loss during operation due to radio control signal loss between transmitter and receiver. If the receiver is not able to receive any signal from the transmitter, the throttle setting on the receiver will default back to its original setting. Setting: 1. Turn on the transmitter. 2. Connect power on the receive r, the LED on the receiver will turn solid. 3.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM GT3X 包装内容 Packaging content 3 channel 2.4G transmitter (USM-GT3X) 1 3 通2.4G发射机(USM-GT3X) 1 3 channel 2.4G receiver (FS-A3) 2 3 3 通2.4G接收机(FS-A3) User manual 1 说明书 FCC Statement 1 声明 FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM