User's Manual

13. Fail safefunction

接收机操作说明

13.01 Failsafe Instruction

1.功能说明

失控保护功能是对模型车或船进行失控保护，避免因失控造成损失。主要是对油门通道进行控制，当接收机接收不到控制

信号时，接收机的油门通道将自运行到当初设定的值，以免误动作。

2.设定方法

a. 将发射机开通电源进入工作状态。

b. 将接收机接通电源进入工作状态，此时信号灯恒亮。

c. 控制发射机的油门通道，使油门控制伺服器或调速器进入刹车或熄火状态，然后保持不动。

d. 此时将接收机的设定键（如图按下），此时接收机LED信号灯会闪烁，并在3秒左右停止。

e. 设定完成

3.测试

a. 将发射机打开进入工作状态。

b. 将接收机接通电源进入工作状态。

c. 将发身机关闭电源。

d. 此时可看到油门通道的伺服器便会自动进入设定状态的位置

e. 以上动作如果可以完成表示设定OK

1.Function

Failsafe aims to prevent out-of-control driving of RC car orRC boat.If the Receiver is not able to receive

any signal, from the control to throttle,the parameter of throttle on receiver will turn back to its original

setting.

2.Setting

a.Turn on the Transmitter switch;

b.Turn on

the Receiver switch.the LEDwill be lighting;

c.Adjust Transmitter's Throttle,make the car/boat to stop or flameout, then keep still.

d.Press the "Setting"button on Receiver( as the pic below).the LEDwill be flashing, then stop after

3seconds around, which means setting finished.

3.Te st in g

a.Turn

on the Transmitter switch;

b.Turn on the Receiver switch;

c.Turn off the transmitter switch;

d.Servo of throttle will turn back to its original setting automaticlly'

e.Setting is successful if above procedures finished completely.

FAIL SAFE FUNCTION

Digital propotional radio control system

FS-GT2F

失控保护功能说明