User's Manual

14
FS-lT4S
Digital proportional radio control system
6 Reverse Function
The Reverse function is used to correct a servo or motor's
direction in relation to the systems controls. For example if a
servo is mounted upside down in order to fit inside a model (in
this case steering), when the systems steering wheel is turned
the servo will move in the oppisite direction. To fix this all we
need to do is reverse CH1.
□
To reverse a channel, touch the channel in the list, when
reversed the slider will be at the "REV".
□
To reset the function to the default setting touch the
icon.
□
To return to the main menu touch the
icon.
6.1 End Points Function
End points are the limits of the servos range of movement. There are 2 endpoints per channel, one is the
low endpoint and one is the high end point.
To select an endpoint move the desired control surface in the
direction you wish to change. The currently selected endpoint
will be highlighted in yellow.
Once you have choosen an endpoint, touch the channel you
wish to change.
At the top the current channel, selected endpoint and
percentage are shown. The endpoints location is also shown as
a bar and needle
To edit an endpoint's value drag the wheel at the bottom of the
screen. Left to reduce the value and right to increase the value.
6.2 Subtrim Function
Subtrim changes the center point of the channel, for example if a car's wheels are slightly out of alignment
the sub trim could be used to fix this.
To set the subtrim function:
1. Select the desired channel from the list.
2. Use the wheel at the bottom of the screen to change the value, a real time readout of the channels
position can be seen in this menu as a green bar.
3. Select the back icon to return to the previous menu and save.
The sub trim has a value representing the current subtrim setting, followed by a graphic representation of
the current trim position. Below the graphic there is a real time read out of the channels current position.