User Manual

31
This function is used for adjusting the gyro sensitivity.
If the sensitivity is too high the helicopter will oscillate
(Tail moving from side to side) and if the sensitivity is
too low the helicopter
2. Select pitch or
throttle by
touching its box
located in the rate
column.
3. Use the wheel to
change the value.
4. Test and repeat until
the model can
hover predictably.
Take weather
conditions, wind
and drafts into
account.
This function can be
set with up to 5
conditions.
8.4 Swashplate Mix（Pic.42）
Adjust the motion range
of these three functions
to achieve the desired
maneuverability. Refer
to your models manual
to ensure best results.
Setup:
1. Select aileron,
elevator or pitch..
2. Move the wheel to
modify the value.
3. Repeat as needed.
This function can be
set with up to 5
conditions.
8.5 Swashplate Ring（Pic.43）
This function is to limit
swash plates range
of movement achieve
different control
difficulties. For example
a beginner might use
a smaller swashplate
ring setting in order to
prevent any extreme
movement caused by
mistakes when flying.
The swashplate ring
will be displayed on
the graph with a real
time display of stick
movement. When stick
movement moves
beyond the swashplate
ring setting, an X will be
displayed showing the
swashplate limited
Setup:
1. Activate the function by touched the function
on/off icon located at the bottom left of
the screen.
2. Move the wheel to change the value.
Pic.42
8.6 Hover Adjust（Pic.44）
If your model is moving up or down, or moving in a
direction when hovering, use this function to correct
this. If the model is gaining or losing altitude, adjust
the throttle setting. If the model is drifting back or
forward then adjust the pitch setting.
Setup:
1. Move the wheel
to change the
value.
2. If required this
function can be
assigned to a
switch or logic
switch .
3. Test and repeat
until you have
the desired
result.
This function can
be set with up to
8.7 Gyroscope （Pic.45）
Pic.43
This function is used to edit the pre-programmed
mix control of the helicopter
’
s aileron, elevator and
pitch.
position, however the system will still display the
sticks real position, shown as a line leading to a box.
Setup:
1. Assign both throttle control and pitch control in
the switch assignment menu
[icon]
.
Pic.44
will be sluggish and
unresponsive. The
default channel is
channel 5.
Pic.45