User Manual

29
Setup:
1. Touch either
elevator rate or
rudder rate to
select it.
2. Use the wheel to
change the value.
Setup:
1. Touch the box in
either the
[UP]
or
[DOWN]
columns
to select it.
2. Use the wheel
to change the
value. Repeat as
necessary until
both the up and
down side of both
rudders are set.
7.8 Rudder Function（Pic.37）
The rudder function is used for aircraft that have
2 rudders. Each rudder can set its own ratio to the
sticks movement.
Pic.37
7.9 V-tail（Pic.38）
The V-tail option will
only be visible in the
model setup menu
when both elevators
and rudders are not
ticked.
The V-tail function has
2 variables, elevator rate
and rudder rate, which
control how much
elevator and rudder are
applied when the sticks
are moved.
Pic.38
For example if rudder
1 is set to 10% on the
up side, when the stick
is at 100% movement
in that direction, the
rudder will only move
10% of its full range of
motion.
The V-tail function is used for planes that have no
elevators and has a V-tail rudder configuration.