Installation Guide

Page of
6
5
STEP 5: Stake canopy
A) Stake canopy by driving stakes through the holes at the foot of each leg. The fabric canopy top
also has integrated guy ropes that can be staked as well.
B) Use additional weights (sand bags, other heavy objects) on each foot or place legs
twelve inches down into sand to help secure set up for beach use. Stakes alone will not secure
canopy in sand or soft soil.
C) To stabilize the canopy,unroll the guy rope on the corner of the canopy.Tie the other end to the
stake and then drive the stake into the ground to secure.(Adiust the stake position to tighten up
the guy rope.)Repeat for each guy rope.
DISASSEMBLY
Store all poles and stakes in their corresponding bags to prevent possible tearing
or damage to fabric.
STEP 1：Remove the stakes
Carefully remove stakes by pulling out the hook ends.
Remove excess soil from the stakes and store them in their bag.
STEP 2: Take down the canopy
A) Remove any accessories if installed. Fold for storage.
B) Press the push button located in the middle of each leg , and carefully lower each leg making
sure all legs are level before proceeding. Repeat until frame is lowered to ground.
C) Remember the fasteners are inside roof line, on side scissors bars, and at corners. Detach all
fasteners and remove fabric completely off frame and fold for storing.
NEVER STORE FABRIC ON FRAME. YOU MAY DAMAGE FABRIC, FRAME, OR BOTH.
D) Press the push buttons found on each leg at each upper corner of frame, making sure that all
sides are detached from snap button. Slowly slide roof line downward while walking in. This
should collapse frame completely.