Instructions / Assembly

Step 7:
Attach the pull handle (R) to the front axle assembly (S) using bolt (C), flat washer (H), lock washer (J), and hex nut (K).
Tighten nut and bolt using flat screwdriver and 10mm wrench.
Step 8:
Attach the wood panels (V&W) to the front, rear and sides of the wagon using bolts (B) and capped hex nuts (L). The
wood panels mount to the outside of the wagon tray. (Note: The bolt should be inserted from the inside of the wagon
tray out through the wood and fixed in place using capped hex nuts on the outside). Tighten nuts and bolts using #2
Phillips screwdriver and 10mm wrench. Be sure not to over tighten as this will push the bolt through the cap leaving a
sharp point.)
Page 5 of 6