TIO A M R N NFO I T N RTA use nce O e r P e f e M I efor uture re b d a Re or f f n i ta & re For all customer enquiries or for replacement parts, contact:- 01325 300303 www.flymo.com eop.customer.services@electrolux.co.
Carton Contents switchbox start/stop levers upper handle cable clip lower handle handle knobs washer grassbox lid bolt Easi-Reel cable winder retaining clip washer pin nuts bolt retaining clip electric cable with moulded plug grassbox pin cutting height spacers (1 fitted to lawnmower & 2 in loose parts pack spanner/scraper tool instruction manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your extension cable must be unwound, wound cables can overheat and reduce the efficiency of your mower. 6. Keep cable away from lawnmower, always work away from the power point mowing up and down, never in circles. 7.
Assembly Instructions Lower handle assembly (A) 1. Insert the lower handle into the handle slots, ensuring that the holes are aligned. 2. Insert the pins and secure with the retaining clips. B Upper handle assembly (B) 1. Insert the nut into the handle knob. (B1) 2. Align the holes in the upper and lower handles and secure with the bolt, washer and wing knob.(B2) 3. Fit the cable to the handle with the clip provided. (B3) Make sure the cable is not trapped between the upper and lower handles.
How to Mow 1. Start mowing the edge of the lawn nearest to the power point so the cable is laid out on the lawn you have already cut. 2. Mow twice a week during the growing season, your lawn will suffer if more than a third of its length is cut at one time and this may also result in poor collection. Do Not Overload Your Mower Mowing long thick grass may cause the motor speed to drop, you will hear a change in the motor sound. If the motor speed drops you may overload your lawnmower which may cause damage.
Easi-Reel Cable Winder R1 Storing your cable in the Easi-Reel cable winder R2 1. Insert the female connector into the top of the cable winder (R1) 2. Place the cable under the cable guide (R2) 3. Turn the cable winder (R3) until all of the cable is wound in.(R4) Warning:- When cable is fully wound, lid becomes heavy R3 R4 Unwinding the cable before re-use 1. Pull the cable by the plug and unwind the cable fully. • Ensure that the cable is released from the cable guide (R2) before using your machine.
Fault Finding Hints Fails to Operate 1. Is the correct Starting procedure being followed? See ‘To Start your Lawnmower’ 2. Is the Power Turned On? 3. Check the fuse in the plug, if blown replace. 4. Fuse continues to blow? Immediately disconnect from the mains electricity supply and consult your local approved Service Centre. Poor Flotation 1. Disconnect from the mains electricity supply. 2. Clean the underside of the hood and the fan blades. 3. Raise to a higher height of cut.
EC Declaration of Conformity I, the undersigned M. Bowden of Electrolux Outdoor Products, Aycliffe Industrial Park, NEWTON AYCLIFFE, Co. Durham. DL5 6UP. Certify that the product:Category........ Electric Hover Make.............. Electrolux Outdoor Products Conforms to the specifications of Directive 2000/14/EEC I, the undersigned M. Bowden of Electrolux Outdoor Products, Aycliffe Industrial Park, NEWTON AYCLIFFE, Co. Durham.
