® Original Instructions TIO A M R INFO T N RTA use nce O e P r e f e M I efor uture re b d a Re or f f n i ta & re N
Carton Contents switchbox start/stop levers upper handle cable clip lower handle handle knobs washer grassbox lid bolt Easi-Reel cable winder retaining clip washer pin nuts bolt retaining clip electric cable with moulded plug grassbox pin cutting height spacers (1 fitted to lawnmower & 2 in loose parts pack spanner/scraper tool instruction manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
current of not more than 30mA. Even with a R.C.D. installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Check your R.C.D. every time you use it. 2. Before use, examine cable for damage, replace it if there are signs of damage or ageing. 3. Do not use the lawnmower if the electric cables are damaged or worn 4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged.
Assembly Instructions Lower handle assembly (A) 1. Insert the lower handle into the handle slots, ensuring that the holes are aligned. 2. Insert the pins and secure with the retaining clips. B Upper handle assembly (B) 1. Insert the nut into the handle knob. (B1) 2. Align the holes in the upper and lower handles and secure with the bolt, washer and wing knob.(B2) 3. Fit the cable to the handle with the clip provided. (B3) Make sure the cable is not trapped between the upper and lower handles.
How to Mow 1. Start mowing the edge of the lawn nearest to the power point so the cable is laid out on the lawn you have already cut. 2. Mow twice a week during the growing season, your lawn will suffer if more than a third of its length is cut at one time and this may also result in poor collection. Do Not Overload Your Mower Mowing long thick grass may cause the motor speed to drop, you will hear a change in the motor sound. If the motor speed drops you may overload your lawnmower which may cause damage.
Removing, Emptying and Refitting the Grassbox M grassbox is full Grassbox Full • As the grassbox fills up, grass will be clearly visible through the window in the lid (M). • When the window is full it is time to empty the grassbox. Emptying the Grassbox • Stop the lawnmower, as described in ‘To Stop your Lawnmower’ and wait until the blade has stopped rotating, BEFORE lifting the grassbox lid. 1. Lift the grassbox lid and rest against the handles (N). 2.
Caring for your Lawnmower Cleaning IMPORTANT: It is very important that you keep your lawnmower clean. Grass clippings left in any of the air intakes or under the hood could become a potential fire hazard. USE GLOVES It is recommended that you clean your lawnmower straight after mowing while the grass is still wet. 1. Remove grass from under the hood with the spanner/scraper tool. (S) 2. Remove the blade, see Figure L, to gain access to the fan and clean with a soft brush. (S) 3.
Fault Finding Hints Fails to Operate 1. Is the correct Starting procedure being followed? See ʻTo Start your Lawnmowerʼ 2. Is the Power Turned On? 3. Check the fuse in the plug, if blown replace. 4. Fuse continues to blow? Immediately disconnect from the mains electricity supply and consult your local approved Service Centre. Poor Flotation 1. Disconnect from the mains electricity supply. 2. Clean the underside of the hood and the fan blades. 3. Raise to a higher height of cut.
EC Declaration of Conformity Husqvarna UK Ltd., Aycliffe Industrial Park Newton Aycliffe, Co. Durham, DL5 6UP, England Declare under our sole responsibility that the product(s); Category........................................ Model(s)......................................... Identification of Series................... Year of Construction......................
