® UltraGlide Original Instructions AT ORM ION F T IN N A RT O P use ence r e M r I e f o f e be re r Read in for futu a & ret
Carton Contents grassbox handle start/stop levers switchbox electric cable with moulded plug instruction manual quick start up guide IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd.
Electrical 1. The British Standards Institute recommend the use of a Residual Current Device (R.C.D.) with a tripping current of not more than 30mA. Even with a R.C.D. installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Check your R.C.D. every time you use it. 2. Before use, examine the cable for signs of damage or ageing, If the cable is found to be defective, take the product to an Authorised Service Centre and have the cable replaced. 3.
Assembly Instructions A C B K! IC CL K! IC CL K! IC CL Preparing your lawnmower for use • Your lawnmower is supplied with the upper handle folded over the machine for packing and transportation. Handle in Operating Position 1. Lift handle as illustrated in figure A. • Do not drop the handle.
K 2 Mowing 1. For the best results mow the outside edge of the lawn in a clockwise direction first. (K1) 2. Then start mowing the edge of the lawn nearest to the power point so the cable is laid out on the lawn you have already cut. (K2) 3. Mow twice a week during the growing season, your lawn will suffer if more than a third of its length is cut at one time and this may also result in poor collection.
Adjusting the Cutting Height Q R Cutting Height Adjustment • Height of cut is adjusted by raising or lowering the blade using the height adjustment lever (Q & R) • There are four heights of cut on this product. (13mm - 32mm) • NOTE A medium height of cut is recommended for most lawns. The quality of your lawn will suffer and collection will be poor if you cut too low.
Caring for your Lawnmower Cleaning IMPORTANT: It is very important that you keep your lawnmower clean. Grass clippings left in any of the air intakes or under the hood could become a potential fire hazard. USE GLOVES. Switch off and remove the plug from the mains before cleaning. It is recommended that you clean your lawnmower straight after mowing while the grass is still wet. 1. Remove grass from under the hood with a piece of wood or similar. (V1) 2. Remove the fan and clean with a soft brush. (V2) 3.
Environmental Information Husqvarna UK Ltd. are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products’ life. • Packaging is recyclable and plastic components have been labelled (where practical) for categorised recycling.
EC Declaration of Conformity Husqvarna AB, S-561 82, Huskvarna, Sweden Declare under our sole responsibility that the product(s); Designation............................Lawnmower Designation of Type(s)...........UG360 Identification of Series............See Product Rating Label Year of Construction...............