Micro Compact 30 TIO A M R N NFO I T AN T R nce e O e s r P u e f e M I efor uture re b d a Re or f f n i ta & re For all customer enquiries or for replacement parts, contact:- ☎ 01325 300303 www.flymo.com eop.customer.services@electrolux.co.
1 Carton Contents switchbox start/stop lever plastic handle knob upper handle washer bolt cable clip nut (if applicable) lower handle electric cable with moulded on plug fixing pin grassbox hood cutting height spacer instruction manual spanner/scraper tool plastic cutters IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
2 6. Keep cable away from lawnmower, always work away from the power point mowing up and down, never in circles. 7. Do not pull cable around sharp objects. 8. Always switch off at the mains before disconnecting any plug, cable connector or extension cable. 9. Switch off, remove plug from mains and examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only Flymo replacement cable. 10.
3 Assembly Instructions A Fitting the Lower Handles to Your Lawnmower (A) 1. Place the end of the lower handle into the slots. 2. Secure lower handles to hood by firmly pushing fixing pin through holes in hood and handle. 3. Repeat on the other side. • NOTE Should a problem occur when securing handle to hood with the fixing pin, carefully lever fixing pin out of location and repeat steps 1 to 3 above. B lock-off button Fitting Upper Handles to Lower Handles (B) 1.
4 Starting and Stopping 1. Form loop in mains cable and push the loop through the slot as illustrated in picture (F). 2. To secure, position loop over the hook and pull the cable back through the slot as illustrated in picture (G). 3. Connect plug to mains. 4. Move handle to the mowing position. See Fig. C. 5. To prevent a ring being cut in your lawn and to clear any residual grass in the collection chute, tilt your lawnmower slightly (H).
5 Adjusting the Cutting Height M cutting head fixing nut cutting head plastic cutter cutting height spacer fan Cutting height spacer must only be fitted between the cutting head and the fan and NEVER between the cutting head and the cutting head fixing nut Cutting Height 1- Lowest Height of Cut Fit the cutting height spacer to the fan and the raised side of the cutting head to the spacer. Cutting Height 2 Fit the cutting height spacer to the fan and the level side of the cutting head to the spacer.
6 • Caring for your Lawnmower It is very important that you keep your lawnmowP er clean. Grass clippings left in any of the air intakes or under the hood could become a potential fire hazard. Cleaning (P) 1. Remove grass from under the hood with a piece of wood or similar. 2. Using a soft brush - remove grass clippings from all air intakes and the grassbox. 3. Remove the cutting head, see Figure N, to gain access to the fan and clean with a soft brush. 4.
Guarantee & Guarantee Policy If any part is found to be defective due to faulty manufacture within the guarantee, Electrolux Outdoor Products, through its Authorised Service Repairers will effect the repair or replacement to the customer free of charge providing: (a) The fault is reported directly to the Authorised Repairer. (b) Proof of purchase is provided. (c) The fault is not caused by misuse, neglect or faulty adjustment by the user. (d) The failure has not occurred through fair wear and tear.