TIO A M R N NFO I T N RTA use nce O e r P e f e I M befor re re u t d u a f Re for n i a t & re For all customer enquiries or for replacement parts, contact:- ☎ 01325 300303 www.flymo.com eop.customer.services@electrolux.co.
Carton Contents switchbox start/stop lever cable clip lock off button washer upper handle nut bolt plastic handle knob lower handles grassbox upper safety flap grassbox lower lower handle fixing screws electric cable with moulded on plug motor cover wheel assembly (x2) deck spanner/scraper tool roller & rear height adjustment assembly (1 lever each side) instruction manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
General 1. Never allow children or people unfamiliar with these instructions to use the mower. Local regulations may restrict the age of the operator. 2. Only use the lawnmower in the manner and for the functions described in these instructions. 3. Never operate the lawnmower when you are tired, ill or under the influence of alcohol, drugs or medicine. 4. The operator or user is responsible for accidents or hazards occurring to other people or their property. Electrical 1.
CABLES IMPORTANT • Use only 1.00mm2 size cable up to 40 metres length maximum. Maximum rating : 1.00mm2 size cable, 10 amps 250 volts AC. • THE VENTURER 320 IS SUPPLIED WITH CABLE WIRED DIRECTLY INTO THE PRODUCT. 1. Flymo Mains Cables and Extension Cables are available from your local Electrolux Outdoor Products Approved Service Centre. 2. Do not wire an extension cable directly to your product yourself.
Cutting Height Adjustment Wheels - Front Cutting Height Adjustment • Height of cut is adjusted by raising or lowering the front wheels and rear roller. • NOTE The wheels and the roller must be adjusted to the same position: HEIGHT OF CUT WHEEL ROLLER Low Hole 1 Position H Medium Hole 2 Position J High Hole 3 Position K • NOTE A medium height of cut is recommended for most lawns. 1. To remove the wheel assembly turn the wheel hub in an anti-clockwise direction.(E) 2.
Starting and Stopping M N P Q To Start your Lawnmower 1. Form loop in mains cable and push the loop through the slot. (M) 2. To secure, position loop over the hook and pull the cable back through the slot (N). 3. Connect plug to mains and switch on. 4. Tilt the handle downwards to slightly raise the front of the lawnmower and to reduce the risk of lawn damage whilst starting. The switchbox is provided with a lock-off button (P1) to prevent accidental starting. 5.
Caring for your Lawnmower Cleaning (U) • USE GLOVES • IMPORTANT It is very important that you keep your lawnmower clean. Grass clippings left in any of the air intakes or under the deck could become a potential fire hazard. 1. Remove grass from under the deck with brush. 2. Using a soft brush - remove grass clippings from all air intakes, the discharge chute and the grass box. 3. Remove the blade, see Figure T, to gain access to the fan and clean with a soft brush. 4.
Environmental Information The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
