User Manual

The Copter jerks at full speed 1. if you use 5S you might use a external
capacitor, or if you already have one it might be
to weak.
2. the ESC might go to its overcurrent
protection. In this case it reduces its max
current to 30A. This reduction can confuse the
FC. Please lower the load in this case.
DIY Instructions: Flashing the KISS ESC 24A
1. Connect the USB-UART to one ESC (RX-TX TX-RX and GND-GND)
2. Unmount all propellers!
3. Connect the USB- UART to your computer and then power the ESC.
4. Wait 5seconds and open a serial monitor (Putty or arduino serial monitor) with 115200 baud
and linwarp enabled.
5. Type in "info" without the ""
6. You will get a serial number besides some other infos.
Note that serial number and repeat this process for all ESC's you like to update.