User Manual

Commissioning of the ESC / speed controller for a brushless electric motor:
• Soldering each of the three motor cables a motor to each one of the three solder
pads (1)
• LiPo power cable with plug solder (2 + 3). IMPORTANT !!! Note polarity, otherwise the
ESC / controller is immediately destroyed when connecting the power supply. The
LiPo can also be damaged.
• Solder signal cable, white or yellow cable (4), the black wire to (5)
ESC/Speed Controller Settings:
A) Programming the throttle path (stick Programming)
Optional: 3D Mode
B) Set the direction of motor rotation (6)
IMPORTANT !!! Change motors setting without propeller mounted, risk of injury!
A) Since the KISS24A RE have very accurate resonators, a throttle calibration isn’t really
needed. The default setting is 1000µS Min signal, 1050µS Start signal and 2000µS full
Throttle signal.
To teach the transmitter path (throttle path) the ESC / controller must be connected to a
receiver or FC, set the throttle signal at full throttle (peak throttle).Connect the LiPo to the
ESC / controller. A beep indicates the confirmation that the programming mode is activated.
Now reduce the throttle signal to minimum (normally 1000μs,), and wait for the restart of
the speed controller (audible signal high-low-high). The throttle pas is now programmed and
the ESC/controller is ready for use.
Caution: The loads that arise for the ESC in the 3D mode, are up to 3 times higher!
3D mode: After the throttle travel has been programmed as described, the 3D mode can be
activated as follows: Disconnect the power supply, put the transmitter signal at full throttle,
connect power again, wait for the beep. Adjusting the throttle to the middle position (half
throttle path) and wait for restart of the ECS/ speed controller (signal: high-low-high). The 3D
mode is now active. Important! Speed controller now starts only at the throttle center
position. Deactivation: Teach new master travel (A).