Instruction Manual

Beta FLUO BASIC Manual 2.02
3/29/2022
How to use the FLUO
During a measurement the FLUO BASIC will calculate three measurement
values, one for X, one for Y, and one for Z.
The FLUO can be used in two modes: the color mode will show XYZ values,
the intensity mode will show only the intensity of the near UV. The mode is
selected in the Configuration shown below.
The LCD shows the actual measurement value. The active light source and
the dominant channel are displayed by the flashing LEDs at the top of the
FLUO device.
Example:
Example 1: green color channel (Y), near UV illumination, Color mode
Example 2: near UV illumination, Intensity mode
RESET the FLUO
Press the RESET button on the bottom side of the device to perform a
RESET. Resetting will delete all internally stored references. The display will
show the device type for a few seconds.
FLUO equipped with near UV LED only
After a few seconds the display will change and show the current firmware
version number
After initialization the device will show ‘0’. The FLUO is now ready for
measurements.