User Guide

Thermal Imagers
Setting Reflected Background Temperature
15
1. Press the softkey labeled Table.
2. Press the softkey labeled Up or Down to move between the materials in
the list. The emissivity value for each material is shown on the screen as
the selection moves between the different materials
3. Press the softkey labeled Done to select the highlighted material.
To set the emissivity value directly:
1. Press the softkey labeled ε.
2. Press the softkey labeled Up or Down to increment or decrement,
respectively, the emissivity value displayed just above the softkey labels.
3. Press the softkey labeled Done to select the set value.
Setting Reflected Background Temperature
(Reflected Temperature Compensation – Ti25
and TiR1 Only)
Compensation for reflected background temperature on the imager is set in the
Background tab. Very hot or very cold objects may affect the temperature
measurement accuracy of the target or object of interest, especially when
surface emissivity is low. Adjustment of the reflected background temperature
setting may improve temperature measurement accuracy.
1. Press G until BACKGROUND appears over G.
2. Press softkey labeled BACKGROUND.
3. Use the sofkey labeled UP or DOWN to adjust the reflected background
temperature.
4. Press BACK/DONE when finished.
Setting File Format
Data stored on the Imager’s SD card can be saved in two different file formats:
.bmp and .is2. This setting is saved and remains valid when the Imager is
turned off and back on. It can always be changed prior to capturing images.
To change the file format:
1. Press a until File Format appears over softkey F3.
2. Press the softkey labeled File Format.