Pacemaker User Manual

ManualsBrandsFluke ManualsMedical EquipmentSIGMAPACE 1000

SigmaPace 1000

Safety Sheet

External Pacemaker Analyzer

Introduction

The SigmaPace™ 1000 External Pacemaker Analyzer

(the Analyzer), is the latest in external pacemaker

analyzer technology. This efficient, handheld

Analyzer satisfies a wide range of external pacemaker

testing.

Table 1-1 describes the symbols used on the

instrument.

Table 1. Symbols

Symbol Description

 Important information; refer to manual.

 Hazardous voltage



Do not dispose of this product as unsorted

municipal waste. Go to Fluke’s website for

recycling information.



Conforms to relevant Australian EMC

requirements



Conforms to relevant Canadian and US

standards

 Conforms to European Union directives

CAT I

IEC Measurement Category I – CAT I

equipment designed to protect against

transients in equipment on circuits not

directly connected to MAINS. Under no

circumstances should the terminals of the

Analyzer be connected to any MAINS

voltage.

Warnings and Cautions

A Warning identifies hazardous conditions and

actions that could cause bodily harm or death.

A Caution identifies conditions and actions that

could damage the Analyzer, the equipment under test,

or cause permanent loss of data.

 Warning

To avoid possible electrical shock or

personal injury, follow these

guidelines:

• Use this product only in the

manner specified by the

manufacturer, or the protection

provided may be impaired.

• Read the Operators Manual

before operating the Product.

• Do not use the product if it

operates abnormally.

• Do not use the product around

explosive gas, vapor, or in damp

or wet environments.

• Use extreme caution when

working with voltages above 30

volts.

• Use the proper terminals,

functions and ranges for the test

being performed.

• Do not connect the Analyzer to a

patient or equipment connected

to a patient. The Analyzzer is

intended for equipment

evaluation only and should never

be used in diagnostics, treatment

or in any other capacity where

the Analyzer would come in

contact with a patient.

Power Supply

Make sure the external battery charger / power supply

is rated and configured for your voltage source, and

compatible with the voltage and current ratings of the

Analyzer. Use only the specified power supply

included with this instrument.

Summary of content (2 pages)

PAGE 1
SigmaPace 1000 Safety Sheet External Pacemaker Analyzer  Warning Introduction The SigmaPace™ 1000 External Pacemaker Analyzer (the Analyzer), is the latest in external pacemaker analyzer technology. This efficient, handheld Analyzer satisfies a wide range of external pacemaker testing. Table 1-1 describes the symbols used on the instrument. Table 1.
PAGE 2
SigmaPace 1000 Safety Sheet Defibrillators and Transcutaneous Pacemakers  Caution To avoid possible damage the Analyzer, do not discharge defibrillator pulses into the instrument. Service and Calibration  Caution To avoid damage to the produt or adverse affects on its performance, allow only qualified technical personnel to service the Analyzer.  Warning To avoid injury to a patient, do not connect the Analyzer to a patient or equipment connected to a patient.