Datasheet

ScopeMeter 190 Series II Fluke Corporation 5
Recorder Modes
190C Series 190 Series II
199C, 196C, 192C, 215C, 225C, 190-204, 190-104
ScopeRecord
™
Roll Mode
Dual or multiple input waveform storage mode, using deep memory
Source and display Input A, Input B, Dual Any combination of inputs, up to 4 channels.
All channels sampled simultaneously.
Bandwidth 20 MHz or 20 kHz, user selectable
Memory depth 27,000 or more data points, each holding min/max. pair of information
Min/max values Min/max values are measured at high sample rate ensuring capture and display of glitches
Recording modes Single sweep, continuous roll,
Start-on-Trigger (through external),
Stop-on-Trigger (through external)
Single sweep, continuous roll,
Start-on-Trigger (through any channel)
Stop-on-Trigger (through any channel)
Stop-on-trigger ScopeRecord mode can be stopped by an individual trigger event, or by an interruption of a
repetitive trigger signal, through any input channel (through External on 190C Series)
Horizontal scale Time from start, time of day
Zoom Ranges from full record overview to zoom in up to sample level, at any record length
Memory Up to 2 dual input ScopeRecord waveforms can
be saved for later recall and analysis.
Two multiple input ScopeRecord waveforms
can be saved internally for later recall and
analysis. Direct storage on external fl ash
memory drive through USB host port.
ScopeRecord sample rate and recording timespan
Time base range 5 ms/div ~ 2 min/div
Recorded timespan 6 sec ~ 48 hr
Time/division in ‘view all’ mode 0.5 s/div. ~ 4 h/div
Glitch capture 8 ns
Sample rate 125 MS/s
Resolution 200 μsec ~ 4.8 sec
Trendplot™ Recording
Single or dual input electronic paperless chart
recorder. Plots, displays and stores meter and
scope measurements.
Multiple channel electronic paperless
recorder. Graphically plots, displays and
stores results of up to 4 automatic scope
measurement over time.
Source and display Any combination of measurements, made on any of the input channels
Memory depth 18,000 points record per input. Each recorded sample point contains a minimum, a maximum
and an average value, plus a date- and timestamp.
Ranges Normal view: 5 s/div to 30 min/div
In view-all mode: 5 min/div to 48 hr/div (overview of total record)
Recorded time span Up to 22 days with a resolution of 1 minute More than 22 days, with a resolution of
102 seconds
Recording mode Continuous roll for the duration of the full
recordable timespan
Continuous recording, starting at 5 s/div. with
automatic record compression
Measurement speed 5 automatic measurements per second or more
Horizontal scale Time from start, time of day
Zoom Up to 64x zoom Up to 64x zoom-out for full record overview,
up to 10x zoom-in for maximum detail.
Memory Up to 2 TrendPlot recordings can be saved for
later recall and analysis.
Two multiple input TrendPlot records can be
saved internally for later recall and analysis.
Direct storage on external fl ash memory drive
through USB host port.
Cursor measurements – all recorder modes
Source Any waveform trace in any waveform display mode (Scope, ScopeRecord or TrendPlot)
Dual vertical lines Cursors may be used to identify Min, Max or Average value of any datapoint in a record, with
time between cursors, time from start or absolute time.
5 ms/div to 1 min/div 2 min/div
6 sec to 24 hr 48 hr
50 ns 250 ns
20 MS/s 4 MS/s
200 μsec to 2 sec 4.8 sec