User Manual

Operating the Meter from the Front Panel
Dual Display 3
3-7
Table 3-2. Display Annunciators and Indicators
No. Name Description
#
O
Meter is in remote mode (remotely controlled)
$
:
the front panel is locked out
%
Ext Trig Meter is in external trigger mode
&
A ? is pressed and secondary function will be selected
'
RELF Relative readings function modifier is selected
(
–
Measurement value in secondary display is negative
)
6
Touch Hold function modifier is selected
*
;
Minimum maximum function modifier is selected
+
MAX and MIN Reading is maximum or minimum
,
AC DC Form of voltage displayed in secondary display
-
2x4 Wire
Resistance measurement method selected (2-wire or 4-
wire)
.
mV µmA kHz Mkg Unit of measurement displayed in secondary display
/
T I
Continuity test or diode test is selected
0
mV µmA Mkg kHz Unit of measurement displayed in primary display
1
AC DC Form of voltage displayed in primary display
2
Slow, Medium, Fast Measurement rate selected (slow, medium, fast)
3
–
Measurement value in primary display is negative
4
Setup . annunciator Which configuration is currently selected
5
Print Meter is in RS-232 print-only mode
6
* (asterisk) Flashes for each Meter sample cycle
7
Auto Range Meter is in auto range mode
8
Manual Range Meter is in manual range mode
9
CAL Error Calibration attempt failed
:
[
High voltage is detected
Displays when voltage is >30 V dc or ac rms