User Manual

414D/419D/424D

Users Manual

Clear

Push :

• 1x = Clear last value

• 2x = Clear all

• 2 seconds = Turn off Meter

Measurements with a Tripod

Measurements with the 419D and 424D that use a tripod

must have the tripod reference set. When set,

 shows on

the display.

Reference Point

The display shows the reference point for a

measurement. The default reference point is from the end

of the Meter. If the beeper is on, the Meter beeps as you

change the reference point. See Figure 9 for more

information.

414D

Push  1x to change the reference point between the

front and the end of the Meter. The display shows

 or .

419D/424D

The Meter automatically adjusts the reference point when

you use the endpiece and

 shows on the display.

Push

:

• 1x = Measure from front



• 2x = Measure from tripod screw



• 3x = Measure from end



Note

The tripod mode overrides other reference

points. The Meter stays in the tripod mode until

you change to a different reference point.

Default

Auto-detect

gwo07.eps